• Citer

Acceptability and safety of 3D printed wrist-based orthoses compared to fiberglass casts for the treatment of non-surgical distal radius- and scaphoid fractures: A randomized feasibility trial

par Tobler-Ammann, Bernadette;Schuind, Frederic ;Voillat, Loïc;Vögelin, Esther
Référence Journal of hand therapy
Publication Publié, 2025

Article révisé par les pairs

• Accès en ligne
• Détails
• Contenu
• Statistiques

Résumé :

Background: Non-invasiveness and comfort are crucial in the conservative management of distal radius and scaphoid fractures. While fiberglass casts are standard, three-dimensional (3D)-printed orthoses offer a promising alternative. Purpose: To compare patient experiences, safety perceptions, and satisfaction between a 3D orthosis and fiberglass cast for distal radius or scaphoid fractures. Study Design: Randomized feasibility trial. Methods: Nineteen adult patients were randomly assigned (3D orthosis group, n = 10; fiberglass cast group, n = 9) and followed until orthosis or cast removal at 6–8 weeks. X-rays at weeks 1 and 6 documented bone healing, with weekly hand therapy visits assessed orthosis satisfaction and function. The Patient-Rated orthosis Satisfaction Questionnaire (PRSEQ) measured satisfaction at weeks 2, 4, and removal. Descriptive statistics and non-parametric correlation tests were used for data analysis. Results: The 3D orthosis group achieved significantly higher PRSEQ scores (mean difference [MD] = 15.7%, p = 0.005 to 0.01, r = −.581 to −.638) and lower perceived pain (MD = −1.0 to −2.2, p = 0.001 to 0.048, r = −0.45 to −0.75) compared to the cast group. By week 4, the 3D group reported less discomfort (MD = −2.2, p = 0.03, r = −0.5) and felt safer (MD = 1.6, p = 0.043, r = −0.46). Routine activities were easier for the 3D group at weeks 2 and 6 (MD = −2.8 to −3.0, p = 0.033 to 0.034, r = −0.49). Satisfaction scores were higher in the 3D group (mean 8.4 vs. 5.6 points, p < 0.001 to 0.01, r = −0.57 to −0.82). Compliance was excellent in both groups. No significant differences were observed in radiological outcomes, finger sensibility, or edema. Bone healing occurred in both groups without fracture displacement; however, one cast patient required subsequent surgery for scaphoid non-union. Conclusions: Treatment with a 3D-printed orthosis appeared feasible and safe, with patients reporting higher satisfaction and better self-perceived hand function compared to a custom-made fiberglass cast, although further research is needed to confirm these findings.