Résumé : DC power systems have a constant DC-link voltage, as well as the advantages such as high stability, high efficiency, small size and light weight; therefore, they are widely used in stand-alone power systems, e.g., the power systems in aircrafts and automobiles, isolated wind power generation systems, etc. Permanent-Magnet Synchronous Generators (PMSGs) possess the advantages including high power density, high efficiency, and high control precision, and have obtained great attention and have been widely used in military, inductry, and daily life. Pulse Width Modulation (PWM) rectifier has been one of the main power conversion topologies thanks to its full controllability. The key point in the dissertation is to study the DC power system consisting of a PMSG to be the main power input device and a PWM rectifier to be the main power conversion topology. The objective of control is to output a constant DC-link voltage in a wide PMSG speed range. Since the PM-excited flux linkage is constant, when the PMSG is working at a high speed, field-weakening is needed to stabilize the stator voltage, further to stabilize the DC-link voltage. Hybrid excitation may be used to realize the field-weakening, but it has complex structure; no auxiliary devices are needed in the field regulation with the armature current, and can be easily realized with the PWM recifier and field-regulation control strategies. In this dissertation, the typical applications of the DC power systems are first introduced, with a comprehensive analysis and elaboration on the relevant research throughout the world. The research work is focused on the DC power system and its stabilization control, which is composed of a PMSG and a PWM rectifier. The involved research content in this dissertation includes the following aspects: 1. DC power system design with a wide-speed-range PMSGAs for the common DC power systems, PMSG with high power density, high efficiency is selected to the system power input device, usually with a variable-speed prime mover. The PWM rectifier with fully controlled switches is chosen to be the power conversion topology, which converts the AC power generated by PMSG into DC power, and supplies the DC load after the DC filter. The matching between the system requirements and the generator parameters are determined. Through finite-element analysis (FEA), a PMSG with strong field-weakening ability and suitable for wide-speed-range operation has been designed and manufactured, and the system test bench has been built based on dSPACE. 2. Study, analysis, optimization and experimental verification of the traditional control strategiesAccording to the PMSG designed in part 1, the DC-link model has been built, as well as the control model of the traditional control strategies, e.g., field-oriented control (FOC), direct torque control (DTC), and the effectiveness of the DC-link voltage stabilization control has been verified in a wide speed range. The theory of active damping has been proposed and analyzed, and has been utilized in the DC-link voltage control. When the load on the DC-link changes, the dynamic response of the DC-link voltage has been greatly accelerated, and it recovers quickly to its reference value. In the meantime, the performance influence of the prime mover speed on the actual system test bench should be considered. Finally, the performance of FOC and DTC has been compared and analyzed. 3. Analysis and experimental verification of the direct voltage control (DVC), and the comparative study of all the studied control strategiesThe derivation process of DVC has been theoretically analyzed: the inner current loops in FOC have been eliminated to obtain the direct voltage field-oriented control (DVFOC); the reference value of d-axis voltage in DVFOC has been replaced by the product of the stator voltage calculated by the speed and the load condition, and the sine value of load angle generated by the DC-link voltage PI controller, in order to form the DVC-1. Further, the DC-link voltage PI controller directly outputs the reference value of load angle and it becomes DVC-2. Finally, the comparative study has been carried out among all the studied control strategies.