par Ozkan, Alp 
;Dufour, Thierry ;Silva, Tiago;Britun, Nikolay;Snyders, Rony;Reniers, François ;Bogaerts, Annemie A M B A.
Référence Plasma sources science & technology, 25, 5, 055005
Publication Publié, 2016-08
;Dufour, Thierry ;Silva, Tiago;Britun, Nikolay;Snyders, Rony;Reniers, François ;Bogaerts, Annemie A M B A.Référence Plasma sources science & technology, 25, 5, 055005
Publication Publié, 2016-08
Article révisé par les pairs
| Résumé : | CO2 conversion into value-added products has gained significant interest over the few last years, as the greenhouse gas concentrations constantly increase due to anthropogenic activities. Here we report on experiments for CO2 conversion by means of a cold atmospheric plasma using a cylindrical flowing dielectric barrier discharge (DBD) reactor. A detailed comparison of this DBD ignited in a so-called burst mode (i.e. where an AC voltage is applied during a limited amount of time) and pure AC mode is carried out to evaluate their effect on the conversion of CO2 as well as on the energy efficiency. Decreasing the duty cycle in the burst mode from 100% (i.e. corresponding to pure AC mode) to 40% leads to a rise in the conversion from 16-26% and to a rise in the energy efficiency from 15 to 23%. Based on a detailed electrical analysis, we show that the conversion correlates with the features of the microfilaments. Moreover, the root-mean-square voltage in the burst mode remains constant as a function of the process time for the duty cycles <70%, while a higher duty cycle or the usual pure AC mode leads to a clear voltage decay by more than 500 V, over approximately 90 s, before reaching a steady state regime. The higher plasma voltage in the burst mode yields a higher electric field. This causes the increasing the electron energy, and therefore their involvement in the CO2 dissociation process, which is an additional explanation for the higher CO2 conversion and energy efficiency in the burst mode. |
